Control.com - Nerds in Control

How to set IP address of NOE 771 01 having only its GLOBAL ADDRESS?

Each Noe module has a standard IP: 84.16.102.142 which You can change if You use Schneider tools for Noe.

ST

Obtain the Quantum NOE 771 xx Ethernet Modules User Guide 840 USE 116 00 Version 5.0

From the manual...

As shipped from the factory, the NOE 771 xx module does not contain an IP address. If you have not programmed the unit with an Ethernet configuration extension, the module does not contain an IP address. When the module starts up
without an IP address, the module will attempt to obtain an IP address from the network’s BOOTP server. You can use Concept or ProWORX to assign an IP address, default gateway and sub network mask. See the section, Configuring the Ethernet Address Parameters. You can also assign IP address parameters using the BOOTP Lite software utility.
See Using BOOTP Lite to Assign Address Parameters in this chapter.

The manual describes how to change the default IP (MAC address) to one compatible with your network.

Hello!

Thank you for your help. But I need your help once more.

I cannot connect to NOE 771 01 from Concept if I use default module’s IP address derived from its MAC address.
But in the same time I am able to connect to NOE’s web server with this IP address.

PLC’s configuration: 140 CPU 534 14A, 140 NOE 771 01.
MAC address - 00-00-54-11-2c-03, derived IP address - 84.17.44.3.
Using Concept version 2.6 XL SR1

What is the problem?