Control.com - Nerds in Control
Select Page: 1
Control.com member...
Member Information and Posts by ahdash |
Looking for information or experience with turboline 3000
replacing brush exciter by brushless exciter
GE power generation gas turbine tripped on reverse power
New Replies:
hi Dear, can you advice, how to check droop percentage set point? and how to correct. unfortunately...
we solved the problem, we found the breaker F3 which transmit the signal from PT to the reverse...
upgrade of GE turbine new control system
New Replies:
yes, dear it because of lack of spares and engineers...
Frame 5 mark II GT we still unable to start the machine
New Replies:
Hi dear
I would like to inform you that, we have started our machine and put online. thank you a...
I would like to confirm about one thing???
While we are going to replace VPR2 we found a hole...
Yes you are right, the rate of Acceleration is too slow; the temperature reaches about 500C.
Is...
Cummins Diesel Generator Trips when supply extended to load.
New Replies:
it seems to me like you have a common fault, caused by ground. check the wiring, junction boxes,...
you check gen protection? what kind of protection you have??
...
Usage of hydraulic oil in GE Frame V gas turbine
New Replies:
I have got one strange behavior. GT frame 5, Mark II control system was running idle, then all of a...
Select Page: 1
Your use of this site is subject to the terms and conditions set forth under Legal Notices and the Privacy Policy. Please read those terms and conditions carefully. Subject to the rights expressly reserved to others under Legal Notices, the content of this site and the compilation thereof is © 1999-2013 Nerds in Control, LLC. All rights reserved.
Users of this site are benefiting from open source technologies, including PHP, MySQL and Apache. Be happy.
Fortune
The trouble with a kitten is that
When it grows up, it's always a cat
-- Ogden Nash.
