Select Page: 1 member...
Member Information and Posts by namira
Topic: Sensor technologies.
from the Mech E. department...
Drum level compensation
Originally posted by Naji on 6 June, 2012 - 1:17 am
lost in the world of corrections
New Replies:
I understand from the boiler data (P&T), the density of the steam and water can be determined....
Posted by Naji on 29 May, 2012 - 9:44 am
What determines the set point for boiler-turbine loads!!
Topic: Continuous process industries, DCS questions.
from the Control department...
Drum level measurement
Posted by Naj on 27 May, 2012 - 1:38 am
correlations for drum level correction
Topic: Power generation equipment control.
from the Mech.E department...
boiler feed pump scoop control
Originally posted by Naji on 9 May, 2012 - 8:25 am
What is scoop control for boiler feed pumps?
New Replies:
Very very useful again. Thanks Shailendra !!...
Thanks Rishi, Appreciated !...
Topic: Power generation equipment control.
from the Automation List department...
What makes a generator increase load
Originally posted by kumarash on 10 August, 2008 - 3:49 pm
What makes a generator coupled to a gas turbine increase load when load raise command is issued to Mark V
New Replies:
Thanks a trillion CSA. I happened to stumble upon this post while trying to figure out how a...
Select Page: 1

Your use of this site is subject to the terms and conditions set forth under Legal Notices and the Privacy Policy. Please read those terms and conditions carefully. Subject to the rights expressly reserved to others under Legal Notices, the content of this site and the compilation thereof is © 1999-2014 Nerds in Control, LLC. All rights reserved.

Users of this site are benefiting from open source technologies, including PHP, MySQL and Apache. Be happy.

Yesterday upon the stair
I met a man who wasn't there.
He wasn't there again today --
I think he's from the CIA.
Advertise here
our advertisers
Help keep our servers running...
Patronize our advertisers!
Visit our Post Archive