Control.com

Using frrjiftest.vbp w/ Fanuc R-J3

Search Forums New Posts
J

Thread Starter

Joe at Urschel

I would like to input a position offset into the R-J3 controller. The robot came with the frrjiftest.vbp VB6 demo CD. However, I can't get the demo to connect to the robot. The ethernet connection pings both ways. What do I have to set up on the robot control, system variables, host comm, etc.?

Thanks,
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
bertus Is your pc or laptop not capable of using win 11? Off-Topic 6
B Remote IO using rs485 (or twisted shielded pair) with 4-20ma on both ends Instrumentation & Measurement 6
J When using a small robotic arm, what is your biggest frustration? Robotics 1
F Applying Hart communication across 2088 pressure transmitter using DS8500 hart modem General Communications Chat 8
godslave42 MARK 6e simulation using toolboxst watch window General Software Chat 1
Similar threads
Is your pc or laptop not capable of using win 11?
Remote IO using rs485 (or twisted shielded pair) with 4-20ma on both ends
When using a small robotic arm, what is your biggest frustration?
Applying Hart communication across 2088 pressure transmitter using DS8500 hart modem
MARK 6e simulation using toolboxst watch window

You May Also Like

Top