Control.com

DC servo motor not running

Search Forums New Posts
D

Thread Starter

Denson

Hi We got a new DC servo motor and it is not running at high speeds. Some times it will be running at a speed of Max 1200 rpm and got struck. What could be the possible reasons for this? Is it because of brush contact?
 
K

Ken Emmons Jr.

Are the brushes getting stuck maybe? Does there seem to be a lot of debris or anything when you take them apart? Check the brush springs. It might be worth putting a dial indicator on the brush contact points (With Power off!!!) to see if they are uniform (IT sounds far fetched, but is maybe something to try). Will it start spinning by hand, or is it locked up good?

KEJR
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
BN.Xoai PC control with c# . servo motor control Programming 2
N Controlling a Servo Motor having a servo motor drive using Advantech uno-137 embedded automation computer and a EtherCAT coupler Programmable Logic Controller - PLC 0
A AC servo motor not stationary in idle state Motion Control 25
M What Type of servo motor would work well for a pop-up target? Motion Control 2
A Xinje servo motor homing problem Motion Control 3
Similar threads
PC control with c# . servo motor control
Controlling a Servo Motor having a servo motor drive using Advantech uno-137 embedded automation computer and a EtherCAT coupler
AC servo motor not stationary in idle state
What Type of servo motor would work well for a pop-up target?
Xinje servo motor homing problem

You May Also Like

Top