V
Hello,
I would like to run long NC-programs on my milling machine MHP with CNC Hydrapath III. Need advice how to:
1. Set up the system to use drip-feed mode, e.g. to run the program from PC in real time.
2. Extend - as an alternative - the CNC memory up to 1 MB.
Can someone advise?
Vladimir
I would like to run long NC-programs on my milling machine MHP with CNC Hydrapath III. Need advice how to:
1. Set up the system to use drip-feed mode, e.g. to run the program from PC in real time.
2. Extend - as an alternative - the CNC memory up to 1 MB.
Can someone advise?
Vladimir