Control.com

Multiple two hand stations

Search Forums New Posts
W

Thread Starter

wrightsr

Is there a way to wire two hand controls so that a machine can function 1) either control can start the process alone or 2) both controls can start the process together? The machine operates in three modes: process A alone, process B alone, or processes A and B together.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
danielvitale Multiple modbus slaves in unique bus rs485 Modbus 7
A Using multiple slave with single master on same Modbus TCP port Modbus 2
F Storing multiple 32bit float values in consecutive 16bit registers, is this an error or an old trick? Programmable Logic Controller - PLC 4
E Doubt about AGA nº 3 report straight pipe requirement for multiple fittings upstream Instrumentation & Measurement 0
B BN3500 Multiple Channel "Not Ok" alarm Instrumentation & Measurement 0
Similar threads
Multiple modbus slaves in unique bus rs485
Using multiple slave with single master on same Modbus TCP port
Storing multiple 32bit float values in consecutive 16bit registers, is this an error or an old trick?
Doubt about AGA nº 3 report straight pipe requirement for multiple fittings upstream
BN3500 Multiple Channel "Not Ok" alarm

You May Also Like

Top