Control.com

Shutdown instrumentation isolation on gas fired boilers, heaters, etc.

Search Forums New Posts
D

Thread Starter

Dillon Abdool

Hello All,

Can anyone advise on the accepted practices for installing isolation valves on tapping points or at transmitters/switches for measurements used for boiler shutdown/trip? I tried looking at the NFPA 85 but could not find anything definite.

Maybe I'm looking at the wrong standard/specification. Please let me know where I should look.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
R MV Motors Start Permissive Time Delay after Shutdown Power Generation 1
dange.T ACS 550 ABB DRIVE EMERGENCY SHUTDOWN Programmable Logic Controller - PLC 0
T Ship paralleled generator shutdown issue Power Generation 2
C Frame 9E fired shutdown issue Power Generation 4
Zikwa What is the conditions to start cool down off of gas turbine 9fa mark 6e after normal shutdown ? Power Generation 7
Similar threads
MV Motors Start Permissive Time Delay after Shutdown
ACS 550 ABB DRIVE EMERGENCY SHUTDOWN
Ship paralleled generator shutdown issue
Frame 9E fired shutdown issue
What is the conditions to start cool down off of gas turbine 9fa mark 6e after normal shutdown ?

You May Also Like

Top