Analog signal splitter with -1/+1 mA input/output range?

from the Forum department...

Posted by sco on 15 September, 2009 - 1:54 pm

For a project I need a signal splitter with -1/+1 mA input and configurable outputs. The outputs should be able to handle -1/+1 mA and 4-20 mA ranges. Does anyone know a product like this on the market? Thanks...

Reply to this post...

Posted by Roy Matson on 16 September, 2009 - 12:33 am

Perhaps you could try for a voltage input and use a shunt resistor,
It might be easier to find.
Good Luck
Roy

Reply to this post...

Posted by Don Lupo on 16 September, 2009 - 7:43 am

For +/-1mA outputs, Acromag can offer a special single channel solution.

If you'd like to discuss your requirements, please email me.

Kind Regards,

Donald Lupo
dlupo@acromag.com

Reply to this post...

Posted by Mark Mazzeo on 16 September, 2009 - 8:05 am

Might want to check out the signal splitter from Phoenix Contact:

Signal Multiplier
MCR-FL-C-UI-2UI-DCI

Hope this helps.
Mark

Reply to this post...

Your use of this site is subject to the terms and conditions set forth under Legal Notices and the Privacy Policy. Please read those terms and conditions carefully. Subject to the rights expressly reserved to others under Legal Notices, the content of this site and the compilation thereof is © 1999-2010 Nerds in Control, LLC. All rights reserved.

Users of this site are benefiting from open source technologies, including PHP, MySQL and Apache. Be happy.

Internet Explorer 6.0 Fix

Fortune
Wiker's Law:
Government expands to absorb revenue and then some.