Diagnostic message in Mk6 controller

E

Thread Starter

ESKAY

Dear CSA and Mk6 experts...

Ours is a Fr5 Mk6 controlled Turbine,which is a TMR controller. A new diagnostin alarm appears in VCMI of "S" controller, with Diag.alarm Drop# 65 - 64 - and 48 for VME error bit5- bit 4 and VME error bit total#1 detected,with logic at "1".

Tried to RESET the alarm at the Diag.page and as well on the VCMI card of "S" core. But alarm yet remains"1". Kindly advise how to get rid of this Diag.Alarm. Will this diag.alarm affect the turbine performance in any way?

Thanx in advance...

Regards..
 
Top