Control.com - Nerds in Control
from the Forum department...
Low-cost controller with DNP3 support?
  | Posted by iacomm  on 2 November, 2011 - 12:18 pm |
Can anyone suggest a PLC or RTU that is reasonably priced (say, low 100's of dollars) that supports DNP3 protocol? I don't need a lot of I/O, and I just need one or two DNP3-compliant devices for protocol testing. Opto22 has a solution that costs close to $2K (controller $865, power supply $220, rack $125, I/O $104, and software $399). Can I do any better than that? Thanks!
|
Hi,
These guys have a test program for $1500.
http://www.trianglemicroworks.com/ProductPage.aspx
http://www.trianglemicroworks.com/documents/Protocol_Test_Harness_F act_Sheet.pdf
Good luck,
Mark
http://www.peakhmi.com/
These guys have a test program for $1500.
http://www.trianglemicroworks.com/ProductPage.aspx
http://www.trianglemicroworks.com/documents/Protocol_Test_Harness_F act_Sheet.pdf
Good luck,
Mark
http://www.peakhmi.com/
|
> Can anyone suggest a PLC or RTU that is reasonably priced (say, low 100's of dollars) that supports DNP3 protocol?
Opto 22's PAC Project Basic software is free and might be all you need.
-Mary
Opto 22's PAC Project Basic software is free and might be all you need.
-Mary
Your use of this site is subject to the terms and conditions set forth under Legal Notices and the Privacy Policy. Please read those terms and conditions carefully. Subject to the rights expressly reserved to others under Legal Notices, the content of this site and the compilation thereof is © 1999-2013 Nerds in Control, LLC. All rights reserved.
Users of this site are benefiting from open source technologies, including PHP, MySQL and Apache. Be happy.
Fortune
Yesterday upon the stair
I met a man who wasn't there.
He wasn't there again today --
I think he's from the CIA.
Servo, stepping motor control, analog & web HMI in one system!
Control.com is the largest Automation community on the web. Learn how to advertise here now...
