Control

Network descriptors in PLC file

R

Thread Starter

ross downton

some of our network descriptors and comets <i>comments?</i> have gone out of sequence. can the .pcm file for this be edited and saved to correct this problem or do i have to type them all in again?

<i>Moderator's note: It looks as if he is talking about Allen Bradley/Rockwell Automation PLC</i>
 
R

ross downton

> <i>Moderator's note: It looks as if he is talking about Allen Bradley/Rockwell Automation PLC</i> <

no this is modsoft software

<i>Thanks, I could not tell and my google search brought up Allen Bradley for some reason - Moderator</i>
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
MarcoMontemurro Communication lost with all devices In a modbus rtu network when one of the devices went off Modbus 2
P ABB PGP HMI Network Discrepancy - Seeking Configuration Assistance Distributed Control Systems - DCS 0
A A master system missing, Three PLCs communicate with each other through ethernet network, is that a DCS Distributed Control Systems - DCS 2
A PCS 7 Management Console Not Working Properly Says Must be Reinstalled when Adding an IPC to Network Distributed Control Systems - DCS 0
Chill2130 Change a Profibus bus network to a Ring Network with a wireless leg General Automation Chat 0
Similar threads
Communication lost with all devices In a modbus rtu network when one of the devices went off
ABB PGP HMI Network Discrepancy - Seeking Configuration Assistance
A master system missing, Three PLCs communicate with each other through ethernet network, is that a DCS
PCS 7 Management Console Not Working Properly Says Must be Reinstalled when Adding an IPC to Network
Change a Profibus bus network to a Ring Network with a wireless leg

You May Also Like

Top