Control.com - Nerds in Control
from the Forum department...
Flame Detector Cleaning
  | Posted by Jeff Hurt  on 24 September, 2012 - 10:28 am |
I'm looking for instructions/advice on cleaning Honeywell flame detectors on a Frame 7 gas turbine. The detectors we purchase from GE don't contain any instructions and I haven't been able to find anything on the internet specifically concerning solutions and materials. Thanks in advance for your help.
| Posted by CSA  on 25 September, 2012 - 12:54 am |
A cotton rag wetted (not soaked) with isopropyl alcohol seems to work best for any hydrocarbon-based grime; otherwise just plain water on a rag will work for most dirt.
I believe the lens area is water-resistant, at a minimum, but it probably shouldn't be submerged.
I believe the lens area is water-resistant, at a minimum, but it probably shouldn't be submerged.
| Posted by Jeff on 26 September, 2012 - 2:21 pm |
Thank you!
Your use of this site is subject to the terms and conditions set forth under Legal Notices and the Privacy Policy. Please read those terms and conditions carefully. Subject to the rights expressly reserved to others under Legal Notices, the content of this site and the compilation thereof is © 1999-2013 Nerds in Control, LLC. All rights reserved.
Users of this site are benefiting from open source technologies, including PHP, MySQL and Apache. Be happy.
Fortune
Twenty Percent of Zero is Better than Nothing.
-- Walt Kelly
