Z
i have a problem with the level transmitter masoneilan displacer 12300.
during the calibration on site with water (SG cal = 1, SG service = 0.572, SG cal meter = 1).
when i try to set the span, i get a message on the hart communicator. the message is applied process is too high. can anybody tell what does it mean this message? and what can i do?
during the calibration on site with water (SG cal = 1, SG service = 0.572, SG cal meter = 1).
when i try to set the span, i get a message on the hart communicator. the message is applied process is too high. can anybody tell what does it mean this message? and what can i do?