Error message on Hydrapath III controller

J

Thread Starter

jlaiii

I'm a small startup that purchase a Bridgeport S-24 MHP mill with Hydrapath III controller. As I went through the menus the machine froze and shows "Axis Drive Not Ready" error. I can't get the machine to reset. Do you have any suggestions and know of someone that could help me?

John Avery
[email protected]
 
> I'm a small startup that purchase a Bridgeport S-24 MHP mill with Hydrapath III controller. As I went through the
> menus the machine froze and shows "Axis Drive Not Ready" error. I can't get the machine to reset. Do you have any
> suggestions and know of someone that could help me?

It sounds like one of your servo (axis boards) are not getting a verified signal to the control . do you have the industrial drive's, if so check to see if the green led's are on when you power up.
 
Top