Control

ABB ACS 800 relay

G

Thread Starter

Gil

Hello

My company uses ABB ACS800 inverter in which I need to open a relay on X25 in the drive panel.

The relay is on X25 where the power (+24V) is connected to port 2, and the relay should close the circuit between port 2 to 3.

the communication is Modbus over Ethernet. I have the RETA-02 module.

what would be the address and the parameter sent in order to activate this relay?

Thanks
Gil
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
T ABB ACS 800 Drive Overload setting and Over current limit setting. Electrical Engineering 10
N ABB ACS Inverter - Match control frequency to input frequency? General Automation Chat 8
R ABB ACS 800 can withstand how much air pressure? General Automation Chat 3
O ABB ACS 800 Siemens S7300 Programmable Logic Controller - PLC 1
M New ABB ACS 800 Direct Torque Drive Motion Control 4
Similar threads
ABB ACS 800 Drive Overload setting and Over current limit setting.
ABB ACS Inverter - Match control frequency to input frequency?
ABB ACS 800 can withstand how much air pressure?
ABB ACS 800 Siemens S7300
New ABB ACS 800 Direct Torque Drive

You May Also Like

Top