G
Hello Friends
I Have a BULLERI CNC (Italy) router with 4 parallel spindles in Y.
the machine control is Bosch CC100.
last month the buttery of the CPU was finished and all the data inside disappear.
we have no backup, no electrical layout, no manuals of how to insert the parameters again.
this machine we took it as "GOODs vs machine" hoping to run it.
in BUlleri in Italy they have no Doc's about since the machine is very old 1994.
the machine is in very good mechanical condition.
and very strong.
the SERVO drives are:
SM10/20tc1 X2
SM15/30TC1 X1
cc100 controller.
i start to think about retrofit it using another controller (MAch 3 software.).
the idea to retrofit sounds as possible and not so difficult to do.
i want only some instruction about the Encoders PinOut the drivers connection and I/O cards pinout.
regards'
Basim
I Have a BULLERI CNC (Italy) router with 4 parallel spindles in Y.
the machine control is Bosch CC100.
last month the buttery of the CPU was finished and all the data inside disappear.
we have no backup, no electrical layout, no manuals of how to insert the parameters again.
this machine we took it as "GOODs vs machine" hoping to run it.
in BUlleri in Italy they have no Doc's about since the machine is very old 1994.
the machine is in very good mechanical condition.
and very strong.
the SERVO drives are:
SM10/20tc1 X2
SM15/30TC1 X1
cc100 controller.
i start to think about retrofit it using another controller (MAch 3 software.).
the idea to retrofit sounds as possible and not so difficult to do.
i want only some instruction about the Encoders PinOut the drivers connection and I/O cards pinout.
regards'
Basim
