Control

GE Multilin 369 and Kepware OPC

A

Thread Starter

ADAM

Is it possible to communicate to GE Multilin 369 using Kepware OPC through Modbus TCO/IP, and if so when I configure the driver in Kepware software, which driver do I choose?
 
F

Fred Loveless

The Multilin could be set to do modbus or it could have a DNP communications module in it. Assuming it is configured for modbus you would select the modbus model.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
R SBOw writes to GE Multilin 845/869 General Communications Chat 1
Z GE Multilin 469 Relay General Communications Chat 1
J Modbus communication Between Multilin 750 & PLC Modbus 0
B GE multilin 369 with a Modbus TCP Modbus 4
P Control multilin 369 from prosoft mvi56-mcm module with controllogix Programmable Logic Controller - PLC 1
Similar threads
SBOw writes to GE Multilin 845/869
GE Multilin 469 Relay
Modbus communication Between Multilin 750 & PLC
GE multilin 369 with a Modbus TCP
Control multilin 369 from prosoft mvi56-mcm module with controllogix

You May Also Like

Top