MARK IV - FRAME 6 - Vibration Filter

D

Thread Starter

Damien PELISSON

Hello,

I would to know the frequencies values which are setting for the filter of the MARK IV vibration monitoring system installed on the frame 6. Is it possible to configure it?

Best regards.
Damien.
 
Damien PELLISON,

If you're referring to the velocity ("seismic") vibration pick-ups typically used with a Mark VI there is no filtering possibility if the standard vibration block is used.

Filtering is typically only used with accelerometer or sometimes proximity probes.

If the offending vibration pick-up was recently installed then it might not be tightly secured to the base, OR it might have a different sensitivity than the one it replaced (an all-too-common happening).
 
Top