Communications From Plc to Servo Drive

B

Thread Starter

Bruce

I am trying to communicate to a Indramat DKC11.1 servo drive with a quantum 434 modbus port to a black box talking rs485. How do you write commands in Proworks Plus to talk to this drive. Sending commands like BCD:04 (CR) If anyone knows how to do this i need to find out how thanks.
 
Do you mean the DKC01.1? The 11.1 is an analog only interface. What information are you trying to change in the drive? You can email me directly if you like. I'm an application engineer for Indramat in Charlotte NC. [email protected]
 
Top