Info about Melsec F2-20

P

Thread Starter

P Jenkin

I know very little (OK, nothing) about PLCs but I'd like to get some know how. I've been given a Melsec F2-20 PLC, but no programmer. I was wondering whether there was a cheap way of programming this device - eg. a piece of PC software & a DIY cable ? Thanks if anyone can advise. I know this article's a bit mickey mouse and doesn't provide info. Apologies for lowering the tone !
 
P

Pierre Desrochers

Unfortunately there is no cheap way. You need a converter module ( F2-20GF1) and Mitsu sells them about $700 can. You will also need a RS232/422 converter and a power supply... also the MEDOC software... Its an old piece of equipment but many are still working fine everywhere... Pierre
 
Top