Control.com - Nerds in Control
Instructions for DISOMAT B plus
New Replies:
>ok, I'll wait:)
>thanks
Where to send?...
ok, I'll wait:)
thanks...
> I am looking a service manual (calibrate exactly password DISOAMAT B Plus) <
I will see...
I am looking a service manual (calibrate exactly password DISOAMAT B Plus)...
What kind of manual you are looking: user manual, communication, etc? Did you try...
Voltage rating for 200kva transformer
New Replies:
Don't get frustrated please. Transformers are used for supplying power to loads. Actually the...
By M Griffin on 11 December, 2009 - 2:29 pm -
Nobody can tell you the transformer voltage rating just from a kVA rating. You need to get the...
Mark-II is installed on one of our turbines. We have faced grounding faults both Speedtronic and 125VDC fromlast 8 years. Recently i have traced these grounds and rectified them. I have also developed a complete case study of this hectic job.
New Replies:
By Phil Corso on 12 December, 2009 - 10:18 am -
Usman Ghani, were you ever involved with the ECPL Fertilizer Plant in Dakari?
Phil Corso?...
Hello everyone,
Being a part of the team working on this Ground Fault Rectification, I am very...
Hello everyone,
Adeel Imtiaz's paper on Ground Fault Rectification is now on controlWiki. It's...
By Adeel imtiaz on 3 December, 2009 - 1:55 am -
Dear ALL
The MARK-II Ground Fault Rectification paper is sent to control.com & wiki.com. I...
how can I generate 12 volts AC or DC using only household water pressure, and what is the smallest this generator can be? Can it be smaller than 120cc?
New Replies:
By Honders on 5 December, 2009 - 10:57 am -
We are generating 20KW from a stream/waterfall. See how at:
...
This popped up during a related search:
http://www.ashdenawards.org/
I haven't looked at it...
By M Griffin on 4 December, 2009 - 1:03 pm -
You need to calculate the energy available based on physics before you go any further. What is the...
I've been interested in all the information on this topic. I have a small stream running right...
Reusing steam from turbine as power source.
Looking for information on Intools calibration module
LAN Upgrade
New Replies:
Thanks for the replies. It looks like we will go to 2003 for the Factory Talk Asset Center server...
By David Ferguson on 27 November, 2009 - 9:14 am -
Yes formerly RSMACC, formerly RSGuardian, formerly Control Guardian ....................... I...
By Ken Roach on 27 November, 2009 - 5:24 am -
Is the Asset Management software the Rockwell "FactoryTalk AssetCentre" product?
I...
By M Griffin on 25 November, 2009 - 5:26 pm -
I can't comment on the Rockwell software specifically, but as for MS Windows Server, a lot of...
confusion over B parameter in Biot - Savart's law
I require a low cost serial DAQ which can support minimum 5 PT 100 sensors. The DAQ should have capability to provide power to the sensors.
New Replies:
By David on 1 December, 2009 - 2:15 am -
Advantech has a single channel RTD module, the ADAM-4013, that supposedly talks over RS-485...
PLC student that just doesn't get it.
New Replies:
Go to
http://www.plcsimulator.net/
You need to create an account first, though.
You can...
data mapping between SCADA and OSI-PI System
New Replies:
Hi Gan,
We have numerous SCADA systems talking to PI using OPC. For real-time systems where the...
By Wassim Daoud on 23 November, 2009 - 12:32 pm -
Hello Gan,
Considering that your Scada system supports OPC natively and as the post above OSI-PI...
LCN Suspect Alarm after connecting app-node TPN server with OPC optimizer
New Replies:
There are many rules that need to be followed to have good communication. The resistors should be...
Run lcn diag - and see "net media" -reset time- try to connect LCN A and look on...
Since the App-node is the last node before the long journey, could it be that the terminal's...
Both cables must have the same length....
LCN slow down when connecting TPN server to Matrikon ODH with OPC optimizer on the App-Node
New Replies:
By Gilbert Waniandy on 26 November, 2009 - 4:06 pm -
Hi Lalas,
My name is Gilbert Waniandy and I am the Support Manager for MatrikonOPC.
I would...
Can some one please tell me, if there are special conditions considered during the construction of an intrinsically safe cables.
New Replies:
By Vahid on 26 November, 2009 - 2:01 am -
May I know that it is a international standard to a local? Is it possible to give its complete...
I'm trying to figure out how to make a PLC and all I can about PLCs and programming of PLCs. I'm currently taking all the classes I can at Sinclair community college in Dayton Ohio. I'm currently majoring in electronics engineering
New Replies:
RSLogix will only work in the AB PLC. You need to write a in a different language if you are going...
By John Correa on 25 November, 2009 - 10:07 am -
It's a good idea to bring to life again old PCs. Make them a home or industrial controller is even...
By M Griffin on 24 November, 2009 - 4:31 pm -
There are really two aspects to the entire question. One aspect is the hardware. The...
By M Griffin on 24 November, 2009 - 3:20 pm -
> First of all u must be clear that this forum is highly professional forum, where engineers and...
Hello,
What you want to do is a great way to learn about electronics but not so great to learn...
By Ananymous on 24 November, 2009 - 4:10 am -
Dear,
You are very much welcome here, but you aim seems only as hobbyist or amateur.
First of...
from the Instrumentation Control & Automation department...
What is the advantage of the Yokogawa Centum CS 3000 over the Centum CSI want to know the advantages and disadvantages of the Yokogawa Centum CS 3000 over the Centum CS. How can i migrate from Centum CS to CS 3000
buy new UCPB cards for MARK V for DLE machines.
Effect of using cache import tool of TPN server on the LCN?
New Replies:
It will not slow down the LCN as a lot less communication will be required.
The only possible...
Temperature Matching System on GE 9FA gas turbine
New Replies:
If you have a GE-packaged and -provided machine, you will have a document called the Control...
Your use of this site is subject to the terms and conditions set forth under Legal Notices and the Privacy Policy. Please read those terms and conditions carefully. Subject to the rights expressly reserved to others under Legal Notices, the content of this site and the compilation thereof is © 1999-2010 Nerds in Control, LLC. All rights reserved.
Users of this site are benefiting from open source technologies, including PHP, MySQL and Apache. Be happy.
Fortune
"He was so narrow minded he could see through a keyhole with both
eyes ..."
