Hello, dear users, I have a question. In the ACS550 drive, I cannot adjust the motor connected to it so that the motor values, namely the frequency, change in remote control mode. And the engine itself spins only at a fixed speed set. Please help me, I'm rereading the manual for a week, but I still can't understand.
ACS550 ABB problems
- Thread starter a7791635
- Start date
| Thread starter | Similar threads | Forum | Replies | Date |
|---|---|---|---|---|
| S | ABB PM573 ETH - after 1 valid poll and response the Modbus communication terminates. | Modbus | 2 | |
| C | Communication between INTOUCH and ABB ACS550 | General Communications Chat | 0 | |
| C | MODBUS ABB ACS550 Connection trouble | Modbus | 2 | |
| P | ACS550 in Vector Control | General Automation Chat | 1 | |
| A | Reset fault in ACS550 drive | General Automation Chat | 1 |
