D
I have set all the parameters as per manual for Modbus operation at 9600bps 8n1.
I am unable to start the drive I am sending the following frame to start the drive:
Address of Drive 2
Function 5
Coil 6
Data 1
Can someone help me, Danfoss service Engineer has refused to help since I have not purchased the drive from their Official System House...
I am unable to start the drive I am sending the following frame to start the drive:
Address of Drive 2
Function 5
Coil 6
Data 1
Can someone help me, Danfoss service Engineer has refused to help since I have not purchased the drive from their Official System House...