Control

Micrologix 1100 to Yokogawa Centum 3000 DCS via Modbus RTU

G

Thread Starter

Gapman

Do I need to create any code within the Micrologix 1100 to get the data out to the Centum 3000 via Modbus RTU. I have an 1763-NC01 cable connected to Channel 0. If so could you please send me an example table? Thanks
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
D NPN NC proximity sensor not being seen by PLC MicroLogix 1100 controller. Programmable Logic Controller - PLC 2
S Reading an ASCII value from bar code scanner into RS Logix 500 programming environment , Processor: Allen Bradley Micrologix 1100 General Automation Chat 1
I AB Micrologix 1100 to Citec6.10 Communication Programmable Logic Controller - PLC 2
M MODBUS on micrologix 1100 and Powerflex4M Modbus 0
B Control MicroLogix 1100 via Java Programmable Logic Controller - PLC 0
Similar threads
NPN NC proximity sensor not being seen by PLC MicroLogix 1100 controller.
Reading an ASCII value from bar code scanner into RS Logix 500 programming environment , Processor: Allen Bradley Micrologix 1100
AB Micrologix 1100 to Citec6.10 Communication
MODBUS on micrologix 1100 and Powerflex4M
Control MicroLogix 1100 via Java

You May Also Like

Top