Control

OMRON PLC : CPM1A and HMI NT2S

W

Thread Starter

Willy O.

I am looking for the cable drawing between a CPM1A PLC and a NT2S (HMI), the HMI is powered by the PLC.
 
C

calvin smith

good morning

The cable you need is omron part #nt2s-cn222 2m or #nt2s-cn225 5m.

hope this helps
 
D

David Wooden

Check out the Knowledge Center at http://knowledge.omron.com/ .There you can download the complete manuals for the CPM1A and the NT screens. One or the other of these manuals will contain detailed drawings of the cable you need. For the CPM1A, you may also need the CIF1? unit, which converts the peripheral port to RS-232 or RS-485.
Best of luck,
David Wooden
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
C PLC WAGO read info of Omron (NJ101 and CJ2M) Programmable Logic Controller - PLC 3
T OMRON PLC withe master slave DP Programmable Logic Controller - PLC 0
T Standalone Omron CP1L PLC to DCS system via Ethernet connection and wireless network Programmable Logic Controller - PLC 0
L cheapest hmi for omron cpm1a plc Human Machine Interface - HMI 6
E omron plc type cpm1a Programmable Logic Controller - PLC 1
Similar threads
PLC WAGO read info of Omron (NJ101 and CJ2M)
OMRON PLC withe master slave DP
Standalone Omron CP1L PLC to DCS system via Ethernet connection and wireless network
cheapest hmi for omron cpm1a plc
omron plc type cpm1a

You May Also Like

Top