Control.com - Nerds in Control
from the Maintenance department...
Using IPC 704 Signal conditioner ( Vibro-meter) with Speedtronic Mark V
Hi,
Need help.
I am looking for any one has tryed to use the IPC 704 Signal conditioner ( Vibro-meter) with Speedtronic Mark V for monitoring the vibration of GE LM2500 Gas Generator.
We got actualy 5 IPC 704 and my aim is to find if it is possible to replace the old vibration chain using an accelerometer ENDEVCO 50 pc/g with an one remote charge amplifier DCS 207-26M3.
Thanks for any help.
Our IPC 704 is: 244-704-000-042.
in: 50 pc/g
out: 200 mv/in/s
HP: 10 hz
LP: 500 hz
Need help.
I am looking for any one has tryed to use the IPC 704 Signal conditioner ( Vibro-meter) with Speedtronic Mark V for monitoring the vibration of GE LM2500 Gas Generator.
We got actualy 5 IPC 704 and my aim is to find if it is possible to replace the old vibration chain using an accelerometer ENDEVCO 50 pc/g with an one remote charge amplifier DCS 207-26M3.
Thanks for any help.
Our IPC 704 is: 244-704-000-042.
in: 50 pc/g
out: 200 mv/in/s
HP: 10 hz
LP: 500 hz
Hi,
My suggestion to you is to test the chain using a shaker table.
Regards
Zyad
My suggestion to you is to test the chain using a shaker table.
Regards
Zyad
Your use of this site is subject to the terms and conditions set forth under Legal Notices and the Privacy Policy. Please read those terms and conditions carefully. Subject to the rights expressly reserved to others under Legal Notices, the content of this site and the compilation thereof is © 1999-2010 Nerds in Control, LLC. All rights reserved.
Users of this site are benefiting from open source technologies, including PHP, MySQL and Apache. Be happy.
Fortune
There *__is* intelligent life on Earth, but I leave for Texas on Monday.
