Control

Using IPC 704 Signal conditioner ( Vibro-meter) with Speedtronic Mark V

D

Thread Starter

DAMENE Amar

Hi,

Need help.

I am looking for any one has tryed to use the IPC 704 Signal conditioner ( Vibro-meter) with Speedtronic Mark V for monitoring the vibration of GE LM2500 Gas Generator.

We got actualy 5 IPC 704 and my aim is to find if it is possible to replace the old vibration chain using an accelerometer ENDEVCO 50 pc/g with an one remote charge amplifier DCS 207-26M3.

Thanks for any help.

Our IPC 704 is: 244-704-000-042.
in: 50 pc/g
out: 200 mv/in/s
HP: 10 hz
LP: 500 hz

 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
B Honeywell PHD RDI connection to ControlLogix's PLC's using factory Talk SE Programmable Logic Controller - PLC 0
K Using peak load to minimise emissions in normal ops (Frame 6s / Mark VI) Power Generation 3
LamijaZ Communication between ABB RTU530 and Siemens 7SJ62 using IEC 60870-5-103 protocol General Automation Chat 0
ducanhasd Control Servo mitsubishi using FB Motion Control 0
G Retrieve engine data via ComAp using Modbus RTU General Communications Chat 0
Similar threads
Honeywell PHD RDI connection to ControlLogix's PLC's using factory Talk SE
Using peak load to minimise emissions in normal ops (Frame 6s / Mark VI)
Communication between ABB RTU530 and Siemens 7SJ62 using IEC 60870-5-103 protocol
Control Servo mitsubishi using FB
Retrieve engine data via ComAp using Modbus RTU

You May Also Like

Top